I'm looking at getting some Eccentric eliminator plates made for the 67 to 73's. I have measured up a set and have got a rough price over the phone for them to be water cut.
They will cost roughly $50 for the 4 plates if 5 sets were made. If more sets are ordered at the same time the cost comes down a little.
I also have a price for the 4 hole balljoint wedge to be cnc machined.
There is a set up fee for the machine of $350 and then each wedge is $15ea. So if 10 sets were ordered it would be $ 65.
I thought I would throw this up and see if there was much interest.
I'm also getting a price for the 65-66 Vario-centric kit just waiting for a price on the weld on brackets. So if you are interested in them let me know as well.
Like Kerry mentions above if I can measure a 3 hole balljoint I could get them made as well.
I would assume that the price would be the same as the 4 bolt. Just need to order enough sets to share the load of the set up cost of the machine($350).
Hopefully he will give me a firm price early next week.
Next week I will also price some grade 8 bolts for both the camber kits and the wedge kits?
I was just looking to see if there was enough interest to make it viable.
Hey Hawko, did this go anywhere? I was talking to oz yesterday and I need to source a wedge kit for the pending Shelby drop on my 65. It's the original 4 bolt type. Oz thought that you may have end up getting them made up. Otherwise, recommendations welcome.
"Hey Steve, I hope we can put this back together" - Ozbilt
Thanks guys. Thought this may be the case. I'll go search for just the wedges. They must be a dime a dozen in the states, if not some of the local suppliers.
I will talk to my machinist down the road from me. He is doing a small job for me ATM & will also do the strut rods, so I imagine the wedges would not be too hard for him to make if we have a template.
The logos and trademarks used on this site are the property of their respective owners.
We are not responsible for comments, advice, opinions, products or services posted by our members, as they are the property of the poster.