Not a lot of progress this weekend, had to go to Brisbane. I managed to get some undercoat and two-pack on the control arms. Did a quick "test fit' pretty sure I need to cut a bit more off the flange for the upper control arm.
Not a lot will be happening in the next few weeks, booked up with work and moving my daughter.
After a couple of trips to Brisbane and moving the daughter into a new apartment I finally had a chance to get back to this project.
First job was to pull the motor from the donna car, so I can do a test fit in the Mustang.
Has been an 'eye-opener' working on these newer cars, removing K frame, motor and transmission.
Here's a few pictures
removed radiator, aircon, ps cooler
Removed all wiring and hoses etc., K frame, then dropped the motor. Had to lift the body to clear the motor.
Does anyone know how they lift these motors with an engine hoist, or which mounting points they use.
The logos and trademarks used on this site are the property of their respective owners.
We are not responsible for comments, advice, opinions, products or services posted by our members, as they are the property of the poster.