New seats in a mustang

[66STNG]

As I an Dwayne are looking at doing a similar interior thought I’d start a new thread so we could all put our input (shit on)..
So,
Front seats are 2017 mustang, relatively easy???
Rear sets not so much..
My thoughts where to strip the covers off them and somehow adapt squeeze, bartstardise them onto the original frames.
.

[66STNG]

[66STNG]

The back rests are split seats, this poses a problem .
I’m thinking of just liquid nails and sitting th seats in. Surely the seat belts will keep the seats and kiddies nice and tight??

[Dwayne]

Looks like they'll fit in well back there, especially with my 2" wider inner wheelhouses.

As for securing the backs, perhaps keep the lower hinges in place and then secure the factory clip from inside the trunk. I've got the steel sheet separating the trunk, so potentially I could use that for mounting something.

[Dwayne]

You might even have room to fit speakers, cup holders etc if you make custom panels to fill in the gaps on the sides instead of using the stock 66 panels.

[66STNG]

Mmmmmmmmmmmmmm cup holders.....

[unilec5544]

here you go, just what you are looking for.

https://www.ebay.com.au/itm/ford-mustan ... Sw831bxSrL

[Dwayne]

Think that's just the upholstery.