Hi all,
I need to get my unfinished mustang into a loading dock, sideways, however the roller door isn’t wide enough.
If anyone has a 65 / 66 mustang in bits, can you measure from the radiator support panel back to the most rearward point of the car (taillight panel I think - when rear bumper is off).
If this works, I can take the front guards off to get it in.
Would be greatly appreciated, as no one in town has a rotator tilt tray that I’m aware of.
65/66 Mustang length without guards
Moderator: Moderators
65/66 Mustang length without guards
1966 Ford Mustang Coupe... [Build in progress]
Re: 65/66 Mustang length without guards
I use wheel dolly's to spin my car around in the garage.
Last edited by Dwayne on Sun Nov 15, 2020 1:12 am, edited 1 time in total.
Re: 65/66 Mustang length without guards
I have a set of those but the problem is that the dock is a meter off the ground. So the issue is getting it up and in.
1966 Ford Mustang Coupe... [Build in progress]
Re: 65/66 Mustang length without guards
I got 4.35m from front of hood bumper mounts to the taillight panel. Measured it without taillights, bumpers, extensions etc.
Last edited by Dwayne on Sun Nov 15, 2020 10:12 pm, edited 2 times in total.
Re: 65/66 Mustang length without guards
I always used a fork lift with slippers on the forks. That is how I got them up in containers.
Kerry
To our wives and sweethearts. May they never meet
To our wives and sweethearts. May they never meet