DIY Adjustable Engine Mounts

Thanks to "buening" from the Vintage Mustang Forums we've got some drawings for adjustable engine mounts for your Mustang.
We have 5 files in total.
Firstly we have the dwg and dxf files for auto cad. These files contain a number of items.

buening wrote:
CAD file has different plates shown above, which were previous runs of these mounts that had different top plates for each mount. The PDFs were established so you didn't have unique top plates for each side, making things a bit easier although it takes a little more steel.
There is also a random drawing in there of my T56 trans crossmember. As stated before, the PDF is printable to scale on 8.5x11 paper. Be sure to measure the scale that I included in the plot to verify that it printed to scale.
The 1.0 should measure exactly an inch.

There is some welding to be done, and the rubber mount is designed to use a rear spring shackle rubber.

Adjustable Engine Mount


Files:
DXG CAD file
DWG CAD file containing drawings for all three heights (STD, 0.5in lower, 1in lower)
PDF drawing for STD height mounts
PDF drawing for 0.5in lowered mounts
PDF drawing for 1in lowered mounts
Bolts required:

4 x 3/8"x 3-1/2" NC
4 x 3/8"x 1-1/4" NC
2 x 1/2"x 3-1/2" NC

If you want a set of these, but are not capable of making them yourself, or you need particular portions of it made, contact ozbilt (Kerry) on this website.
He can also be contacted on his AU mobile - 0450 458 005