Its late and my brain may not be working, but wondering if anyone else sees this as a problem?
I was putting the heater box together, and in addition to the new drake foam kit I bought the foam ends for the heater hore.
Had to cut bits off the end where the pipes come off as they were butted up to the core and there was no where for the foam to sit between the pipes and the core
Got it back together and noticed the pressure of the end foam pushing the heater core over with the pipes now hard up against the casing, and pipe themselves now exiting at an angle....
Is this an issue? should I just pull the end foams off and forget about them? The box is fibreglass and brittle (you can see a crack in it already - was there when I bought it) but broke another bit of it tonight without trying to hard. So am just concerned out the pressure of the core up against it?
The logos and trademarks used on this site are the property of their respective owners.
We are not responsible for comments, advice, opinions, products or services posted by our members, as they are the property of the poster.