Yeah pretty sure mine is 24" too.
Wasn't too hard to fit the big fan.
As you can see, I just used some square tube from bunnings. Screwed that to the backet on the side, then screwed the shroud to that.
Some minor cutting around hoses etc. The fan measures about 17.5" diameter from memory. It has two speeds.
I bring the slow speed on full time with my aircon. And full speed for cooling when required.
Last edited by hybrid on Tue Nov 14, 2017 3:07 pm; edited 2 times in total
A large single fan will cover more area than the two singles also.
What you have to be careful of with fans is not to just look at the CFM ratings. Most are tested with nothing in front of them. If the motors are crap, as soon as you put a radiator in front of them, they won't have the amps to be able to draw enough air through the radiator.
If you get a BF/FG single fan like Hybrid has, you are laughing. I am upgrading my dual AU fans to a single BF/FG fan. Not that I need to, but for 70 bucks who cares.
I can also recommend the Flowkooler high flow water pumps. I had good results with mine on a previous motor.
Last edited by Husky65 on Tue Nov 14, 2017 8:18 pm; edited 1 time in total
can I remove the switch block and run the fan at full speed as I am going to run the fans for ac on a relay that's already in and wired and the rad fan on the other relay that's already in and wired up
if its not too much bother a pic in behind where the pully is ,I have ordered a fan see how it fits or what I have to do when it gets herei onky have about 115 between the rad and pully bolts so a tight fit any pics you could send would be good also
The logos and trademarks used on this site are the property of their respective owners.
We are not responsible for comments, advice, opinions, products or services posted by our members, as they are the property of the poster.