Just wondering how you stick your seals to the door and trunk while you are doing panel alignment before paint. I was mucking around with mine on the weekend and just taped the seals in place but found it didn't really hold them in the correct location or orientation. Is there a better way to just temporarily stick them on before they have to be removed for paint? Or is near enough good enough at this stage?
I thought that might be the case. Do you just use the same glue as when you are doing it for real or a less sticky alternative?
Would you recommend not cleaning the seals before gluing them on for the trial fit so they are easier to remove or once they have glue on them is it a pain in the ass to do the thinners clean to release the anti mold agents?
OK hopefully the last Q on this topic but what should I clean the seals with before install? I was going to just use thinners but now not sure if it is appropriate. I also have wax and grease remover if that is more suitable. Any tips
The logos and trademarks used on this site are the property of their respective owners.
We are not responsible for comments, advice, opinions, products or services posted by our members, as they are the property of the poster.